Filter
Top Products
4 - 2 C156-E097-01EN
5) Do not forcibly push up the end of the header pin of the printed
circuit board unit when handling or setting the drive.
(2) Unpackaging
a) Make sure that the UP label on the package is pointing upward and start unpacking on a level
surface. Handle the drive on a soft surface such as a rubber mat, not on a hard surface such
as a desk.
b) Use care to avoid exerting excessive pressure on the unit when removing the cushions.
c) Use care to avoid exerting excessive pressure on the PCA surface and interface connectors
when removing the drive from the antistatic bag.
d) If the temperature difference between installation locations is 10 degrees or more, leave the
drive in the new location for at least two hours before unpackaging it.
(3) Installation
a) Do not connect or disconnect the connectors or change the terminal settings when the power
is on.
b) Do not move the drive with the power on.
(4) Packaging
a) Before packaging, remove the optical cartridge.
b) Store the drive in an antistatic vinyl bag with desiccant (silica gel).
c) Use the same cushions and packaging supplied with the drive. If they are not available,
ensure that adequate shock absorbent material is used. In this case, some method of
protecting the PCA surface and interface connectors must be used.
d) Apply "UP" and "Handle With Care" labels to the outside of the package.
Figure 4.1 shows the packaging stile. (The form and material of the cushion may be changed.)