Filter
Top Products
Basic Techniques
37
Note: If your television has two (stereo) AUDIO IN jacks, connect the audio plug to the left-channel AUDIO IN
jack.
2. Connect the other ends of the cable to the AUDIO OUT and VIDEO OUT jacks of the camcorder.
3. Insert a previously recorded cassette into the camcorder.
4. Turn on your television and set to the camcorder input mode (consult your television manual for details).
5. Hold down the red button on the CAM/OFF/VIDEO switch while sliding the switch to VIDEO.
6. Press the PLAY button to begin playback.
7. Press the STOP button when finished.
Connecting to a Television without Audio In and Video In Jacks
1. Disconnect the VHF antenna leads from the back of the television. Leave the UHF antenna leads connected.
2. Connect the VHF antenna lead to ANT IN of the RF output adapter. If the cable on the VHF antenna lead is flat
you need to purchase an antenna adapter (300-ohm to 75-ohm transformer). Connect the antenna adapter to the
VHF antenna lead and slide the adapter on to the ANT IN terminal.
3. Connect the 75-ohm coaxial cable of the RF output adapter to the VHF antenna terminals on the back of the
television. If the television is set up to connect to a flat antenna lead you need to purchase antenna adapter (75-
ohm to 300-ohm transformer). Connect the adapter to the 75-ohm coaxial cable of the RF output adapter and
connect the free ends of the adapter to the VHF antenna terminals at the back of your television.