Hitachi DZ-BD70A Camcorder User Manual


 
136
Additional Information
Disc must be
finalized before it
can be played on
another device.
This message will appear if you remove a BD-R/DVD-
RW (VF mode)/DVD-R disc that has not been
finalized.
See *5 on p.139.
113
Drive overheat.
Please retry later.
The temperature inside the camcorder is too high. In this
case, proper writing/reading HDD/disc may not be
possible. Turn off the power, then wait for a while.
Dubbing is not
complete.
This message will appear when dubbing has failed.
End of card. No more recording on this card can be done. Delete
unnecessary stills or use another card.
99, 170
Error occurred.
Please replace disc
or format disc.
Error occurred while recovering DVD-RAM/DVD-RW.
Format the disc. If the same message persists after you
format the disc, use another DVD. Note that all data on
the disc will be erased if the disc is formatted.
See *2 on p.139.
104
Error occurred.
Please replace disc.
An error has occurred with the inserted DVD which
cannot be repaired. Replace the DVD.
Failed to recover
video data.
Corrupted scenes
have been deleted
and disc is usable
again.
Error occurred while recovering HDD/BD. Although the
recovery was unsuccessful, you can continue using HDD/
BD.
Finalize may not be
complete. Finalize
again now?
This message will appear when power is supplied again
and the disc is reinserted after power was shut off during
finalization due to a power failure, etc. Choose “YES” to
make sure finalizing is complete.
113
HDD error has
occurred.
Format the HDD before using the camcorder.
Formatting the HDD will delete all data recorded on it.
104
HDD error has
occurred. Format the
HDD now?
Did you interrupt the formatting of the HDD?
Choose “YES”, and then format the HDD.
Formatting the HDD will delete all data recorded on it.
104
HDD error has
occurred. Formatting
is not complete.
Did you interrupt the formatting of the HDD?
Press RESET to execute system reset. 156
HDD error has
occurred. Restart.
An HDD error probably occurred during editing of a
video file.
Turn off this camcorder, and then connect the AC adapter/
charger to power it again.
The video file will be repaired.
37
HDD/Disc almost
full.
The remaining free space of the HDD/disc is less than
one minute for video. Delete unwanted scenes, or use
another disc.
99, 169
Message Cause & Troubleshooting
Reference
page