Filter
Top Products
- 15 -
iLuv i182 Connector
iLuv i182
Connecting Your PSP, USB Storage Device to iLuv i182
n Connect the supplied iLuv i182 Connector into the dock wall of iLuv i182 carefully.
o Connect your PSP, PMP, USB storage device using an usual USB cable obtained at a
store into iLuv i182 Connector carefully. When your device is connected, the LED indicator
on the [REC/STOP] button will light up in green and blink for a moment. Please wait until
the green light gets steady without blinking.
Important Notes
When connecting to PSP, please make sure your PSP is in “USB Mode”, and the
resolution setting is correctly set for viewing the content on the PSP display.
iLuv i182 is compatible with PSP firmware higher than 2.80 versions.
Only the PMPs that support MPEG4 video codec and AAC audio codec can play back a
file recorded by iLuv i182.
Check your device when the LED indicator on [REC/STOP] button lights up in orange. It
means your device and iLuv i182 are not properly connected. Please reconnect your
device to iLuv i182 after reconnecting the power adaptor to i182 Connector.
When you connect a USB hub or a flash memory card reader to i182 Connector, it may
cause an error of iLuv i182. Do not connect more than two devices to i182 Connector at
the same time.