Filter
Top Products
- 23 -
LED Status Guide
REC/STOP 30 60 120 180 Status
Blink
Blink
Blink
Insufficient space on iPod/Device for
saving the recorded file. Delete the
recorded files in iPod/Device.
If [Auto delete] is active, it automatically
deletes the oldest recorded file when there
is not enough recording space. With this
function, you can avoid the cumbersome
procedure of manually deleting files every
time.
Blink
Blink
Blink
The video content is copy-protected by
Macrovison and cannot be recorded on
your iPod/Device.
Blink
Blink
Blink
An error occurs in the firmware or
iPod/Device is not properly connected to
iLuv i182. First check whether iPod/Device
is properly connected to iLuv i182. If the
symptom appears constantly, upgrade to
the latest version of firmware after
connecting iPod/Device to i182 setup.
Blink
Blink
Blink
An error occurs in iLuv i182 encoder.
Reconnect the power adaptor to iLuv i182
after unplugging it. If you experience this
constantly, upgrade to the latest version of
firmware using i182 setup by connecting
iPod/Device to your PC.
Blink
Blink
Blink
Blink
Blink
If you disconnect iPod/Device from iLuv
i182 in the middle of recording, all of the
LEDs will flash. First, connect iPod/Device
to iLuv i182 again. If the music playlist is
not shown on iPod/Device screen, connect
it to either iTunes or i182 Manager.