Filter
Top Products
- 34 -
Upgrading the Firmware
q Press the [Close] button to exit the i182 setup program, and disconnect your iPod/Device
from the computer and connect it to iLuv i182.
r Disconnect your iPod/Device from the computer and connect it to iLuv i182. iLuv i182 will
be automatically upgraded. Check the LED status to see the firmware upgrading status.
After upgrading the new firmware is done, the LED indicator on the [REC/STOP] button will
turn into steady green. If it doesn’t turn into steady green even after 2 minutes, disconnect
your iPod/Device and AC adapter from iLuv i182, and re-connect them again.
Important Note: When connecting your iPod/Device to iLuv i182 to upgrade the new
firmware, all LED indicators will start blinking in order and rotate for approx. 2 minutes.
When it finishes upgrading the new firmware, the LED indicator will turn into steady green
light. While it is upgrading its firmware, please do not disconnect your iPod/Device and AC
adapter from iLuv i182.