Filter
Top Products
3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS
34
3.
MV-P615
Microphone
cable
AUDIO IN FRONT
connector
2.
4.
1.
Note:
Connecting the provided microphone to the viewfinder.
The provided microphone is a phantom microphone.
1.
Loosen the stopper screw on the viewfinder.
2.
Attach the microphone to the attachment guide on the
viewfinder as illustrated.
3.
Confirm that there is no gap between the microphone and
the viewfinder, and then tighten the stopper screw.
4.
Tighten the microphone screw. The microphone should be
firmly attached.
5.
Connect the cable from the microphone to the AUDIO IN
FRONT connector on the front section of the camera.
6.
Secure the microphone cable using the cable clamp located
on the front of the camera.
3-4 Attaching the Microphone (provided)
3-5 Attaching the Microphone (optional)
Provided Microphone
With the optional KA-A50 microphone holder, the optional
microphones MV-P615 (Phantom microphone) can be used.
Ⅲ Attaching the Microphone with KA-A50
1.
Secure the microphone holder with 2 screws.
2.
Turn the small knob located on the outer side of the
microphone holder anticlockwise to loosen it, and loosen
the large knob located on the inner side in the same way.
Rotate the large knob fully anticlockwise to open the holder.
3.
Attach the microphone to the microphone holder so that
the microphone does not interfere with the cassette cover.
4.
Set the microphone holder so that the height is level, and
tighten the inside and outside knobs to secure the
microphone.
5.
Connect the microphone cable to the AUDIO IN FRONT
connector.
6.
Secure the microphone cable using the cable clamp located
on the front of the camera.
7.
Make sure to perform the correct settings for use of a
phantom microphone.
• When the light mounted on the camera is used at the
same time, if the microphone in use has a long sound
collecting section (ultra-directional type, etc.), the
microphone's shadow may influence the image.
When this microphone is attached, the range that the
viewfinder can be moved to the left will be reduced. Please
purchase a separately sold microphone if you prefer to
observe through the viewfinder using your left eye.
CAUTION:
KA-A50
Microphone holder
2.
4.
1.3.
5.
3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS
33
1.
Loosen the mount ring.
2.
Connect the cable connector.
3.
Attach the lens with its pin aligned with the hole in the mount.
4.
Tighten the mount ring.
Be sure to tighten the mount ring completely. Incomplete
tightening may result in the lens dropping off or disturbed
back focus.
3-2 Attaching the Zoom Lens (optional)
3-3 Attaching the Viewfinder (optional)
CAUTION:
3.
2.
1
4.
5
1
4
3
2
1.
Loosen the stopper screw on the viewfinder.
2.
Connect the connector.
3.
Align the mounting guide with the camera’s viewfinder mount
base and attach the viewfinder.
4.
Tighten the stopper screw.
5.
Tighten the sliding securing ring.
* To detach the viewfinder, reverse the mounting procedure.
Hole
Pin
Mount ring
When unplugging the cable connector, first remove the lens
itself. Then grasp this portion and pull straight out.
Mounting guide
Sliding
securing ring
Viewfinder
mount
base
Connector
Stopper
screw