Filter
Top Products
70
Changing the Menu Settings (Continued)
Menus Settings: [ ] = Factory-preset
GENERAL
DATE/TIME
Enables you to set whether to
display the current time on the
LCD monitor.
OFF : The date/time does not appear.
[AUTO] : The date/time appears for approx. 5 seconds in
the following cases.
•
When the power/mode switch is set from OFF to
STANDBY/ON
•
When playback starts
ON : The date/time is always displayed.
PRESET
Returns all the camera settings
to their default values.
EXECUTE : Performs this function.
[CANCEL] : Returns to the menu screen without
executing reset.
BRIGHT
Enables you to set the brightness
of the LCD monitor or viewfi nder.
Adjust the brightness of the display moving the set lever
to / , then press down.
DROP DETECTION
Prevents damage to the
HDD by turning off the power
automatically when the camera
detects that it has been dropped.
OFF : Disables the function.
[ON] : Activates the function.
To turn the unit on when the drop detection
worked, set the power/mode switch to OFF, and to
STANDBY/ON again.
CAUTION
Setting this function to off increases the chances of
damaging the built-in hard disk if the camera is accidentally
dropped.
FOCUS ASSIST
When the focus assist function
is used, the borderline of the
focused subject is displayed in
the selected color.
[BLUE] / RED / GREEN
REMOTE
Turns reception of the operation
signal from the remote control
on/off.
OFF : The camera does not receive the signal from the
remote control.
[ON] : Enables operation with the remote control.
DEMO MODE
Introduces special features of
the camera when there is no
operation for about 3 minutes
during recording mode.
OFF : Disables the function.
[ON] : Activates the function.
NOTES
•
The demonstration only works when the AC adapter is
connected, not with the battery.
•
If an SD card is in the camera, demonstration will not take
place even if this mode is set to [ON].
OPERATION SOUND
Enables you to set the operation
sound or turn the operation
sound on/off.
OFF : Turns off the operation sound.
[MELODY] : The melody sounds when any operation is
performed.
TALLY LAMP
Set whether to light the tally lamp
while shooting.
OFF : Unlit.
[ON] : Lit.