Filter
Top Products
Troubleshooting
57 www.kodak.com/go/support
Picture quality problems
If... Try one or more of the following
The picture is too dark
or underexposed
■ Use Fill flash (page 16) or change your position so light is
not behind the subject.
■ Move so that the distance between you and the subject is
within the effective flash range (page 16).
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to take
the picture.
■ Increase Exposure Compensation (page 24) and try again.
The picture is too light
■ Turn flash off (page 16).
■ Move so that the distance between you and the subject is
within the effective flash range (see page 16).
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to take
the picture.
■ Decrease Exposure Compensation (page 24) and try
again.
■ Check if you are in Beach or Snow scene mode.
The picture is not clear
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, gently press the Shutter button completely down to
take the picture.
■ Clean the lens (page 65).
■ Make sure camera is not in Close-up mode if you are
further than 0.4 in (1 cm) from your subject.
■ Place the camera on a flat, steady surface.