Filter
Top Products
88
S
ETUP MENU
LCD monitor brightness
Monitor brightness can be adjusted in 11 levels.
Brightness can be set individually for viewfinder and
direct viewing in the recording mode. Turn the mode
switch to the appropriate position before opening the
brightness option in section 1 of the setup menu (p. 87).
Also see page 28.
Use the left/right keys of the controller to adjust bright-
ness, the monitor image changes accordingly. Press the
central button of the controller to set the level.
Auto power save
To conserve battery power, the camera will shut down if no operation is made within a certain peri-
od. The length of the auto-power-save period can be changed to 1, 3, 5, or 10 minutes. When the
camera is connected to a computer, the auto-power-save period is fixed at ten minutes. Auto power
save is set in section 1 of the setup menu (p. 87).
Set LCD brightness
:adjust
:enter
Low High
89
An image can be displayed on the monitor after it is captured.
When used with the continuous-advance or progressive-capture
drive modes (p. 47, 48), the images in the series are played back in
a six-frame index display. Instant playback is activated section 1 of
the setup menu (p. 87). A playback period of two or ten seconds
can be selected. To cancel the playback and save the image
before the end of the playback period, press the shutter-release
button partway down.
Instant playback
Single still images can be previewed immediately after being captured without
instant playback active. Simply continue to hold the shutter-release button down
after taking the picture to display the image. Release the shutter button to end the
playback.
Camera Notes