Filter
Top Products
16
G
ETTING UP AND RUNNING
Changing the memory card
This digital camera is equipped with a internal storage (approximately 14.5MB) so images can be
recorded without a memory card. For increased memory capacity, an SD Memory Card or
MultiMediaCard can be inserted into the camera. When card is inserted, the images are recorded on
the card. For more about memory cards see page 118.
Always turn off the camera and confirm the access lamp is not
lit before inserting or removing a memory card; damage and
data loss may result.
1. Insert the memory card all the way into the card slot and release; the card should catch in the
slot. Insert the card so the face is toward the back of the camera. Always push the card in
straight, never at an angle. Never force the card. If the card does not fit, check that it is oriented
correctly.
2. To eject a memory card, press the card into the slot and release. The card can then be pulled out.
Take care when removing the card as it becomes hot with use.
A memory card used in another camera may have to be formatted before being used. If the unable-
to-use-card message appears, the card should be formatted with the camera. A memory card can
be formatted in section 1 of the playback menu (p. 74). When a card is formatted, all the data on
the card is permanently erased. If the card-error message appears, press the central button of the
controller to close the window; check the Konica Minolta web site for the latest compatibility infor-
mation:
North America: http://www.konicaminolta.us/
Europe: http://www.konicaminoltaeurope.com/
1 2
17
Turning on the camera and displays
Press the main switch to turn the camera on. Pressing the switch again turns
the camera off.
Around the main switch is the mode switch. This switch is used to change
between the recording and playback modes as well as the selecting the
between the monitor and viewfinder display.
Recording mode (Monitor display) - the camera can record images and the
monitor is viewed directly.
Playback mode (Monitor display) - images can be played back and edited. The
monitor is viewed directly.
To use the viewfinder in the playback mode, press and hold
the flash mode button (1) and then press and hold the infor-
mation (i
+
) button (2) until the monitor switches to the
viewfinder position.
Camera notes
Recording mode (Viewfinder display) - the camera can record
images and the monitor is viewed through the viewfinder. The
viewfinder has a built-in diopter. While looking through the
viewfinder, turn the diopter-adjustment dial until the monitor
image is sharp
1
2