Filter
Top Products
- 26 -
5. Motion Detect Setup
Camera select: Select a camera to setup.
For each camera:
Region Viewer: On this viewer, you can set the region and test. The active region is shown with a red grid.
Sensitivity: Setup the sensitivity of brightness in the motion-detection region.
Min. detect area: Setup the rate (sensitivity) of motion detection in the motion-detection region. The larger
the number, the lower the sensitivity. Conversely, the smaller the size(number) is, the higher the sensitivity.
Motion event duration: Setup the recording duration when motion occurs. (1~60 sec)
Region select: - Select all: The region is all selected.
Draw: Click ‘Draw’ and draw the grid by mouse-dragging on the viewer as desired.
Clear all: All regions are cleared.
Erase: Clear specific regions of the grid by mouse-dragging on the viewer as desired.
Test start: Start the test of the motion-detection on the viewer.
Test stop: Stop the test.
The Motion Detect symbol ( ) is displayed on screen when motion occurs in the selected regions.
Camera recording association: Select cameras to be associated and recorded together when motion
occurs at this camera.
[NOTE]: This association will not affect cameras configured to record upon Sensor input.
Output association: Select the output condition(s) that will occur when motion occurs at this camera.
Speaker out: If selected, speaker will be operated according to ‘Speaker, Relay out’ setup when motion
occurs at this camera.
Mail out: If selected, the capture-mail will be sent according to ‘Mail’ setup when motion occurs at this
camera.
Relay out (1,2,3,4): If selected, the relay will be operated according to ‘Speaker, Relay out’ setup when
motion occurs at this camera.