Filter
Top Products
- 8 -
Installation Precautions:
Installing the 4 Port PCI card requires some degree of technical aptitude. If you have no previous experience
in opening up a computer and inserting hardware, it is advisable for you to seek assistance from a more
qualified individual before proceeding.
Also note that in order for the watchdog feature to function, a connection will be required to the Reset Pin of
the PC Motherboard. If this Pin connection is not known, please consult the motherboards installation
manual.
The watchdog will restart the computer automatically if it did not receive any response from the
system for more than 5 minutes.
WARNING:
TURN OFF YOUR PC AND UNPLUG IT BEFORE OPENING THE COMPUTER AND
INSERTING THE HARDWARE
Installation Procedures (with optional accessory ACC-ALM - not included):
1) Insert the I/O Alarm Block (optional accessory ACC-ALM) connector ribbon cable to the GPIO port on the
VISTAPRO 4 main board. Insert the other side of the connector cable to the GPIO port on the I/O Alarm Block.
2) Insert the 4-wire power supply cable to the power supply port of the VISTAPRO 4 main board.
3) Insert the PC Power Pin connector (red cable) to the socket shown for PC Power On Control of the
I/O Alarm Block. (Device for remote PC Power On function: separate QDR-TELS module)
GPIO port
I/O Board Cable connector
Power Supply port for Camera
Power Supply Cable