Filter
Top Products
1.2 Mounting the adapter
All units involved must be switched off before
mounting or dismounting the SCA adapter
on / from the mecablitz or on / from the ca-
mera.
on the mecablitz 40 MZ-..., 45 CL-4 digi,
50–MZ-5, 70 MZ-... and 76 MZ-5 digi:
•
Turn the flash unit’s foot by 90° (40 MZ-... only).
•
Press the retention catch against the casing,
simultaneously pushing the hitherto used stand-
ard foot or SCA adapter out of the guide.
Any cover plate that may still be in place (requi-
red for the 301 standard foot or SCA 300 adapter)
should be gripped in the centre and withdrawn.
on the mecablitz 44 MZ-2:
• Use your fingernail to press up the locking lever
in the middle of the rear side of the mecablitz
and hold it depressed.
• At the same time withdraw the SCA adapter or
standard foot backward.
Any cover plate that may still be in place (required
for the 301 standard foot or SCA 300 adapter)
should be gripped in the centre and withdrawn.
on the mecablitz 54 MZ-...:
• Open the battery compartment cover.
• Press the coloured locking knob in the battery
compartment and simultaneously remove the
standard foot or SCA adapter.
Any cover plate that may still be in place (requi-
red for the 301 standard foot or SCA 300 adap-
ter) should be gripped in the centre and with-
drawn.
☞
10