Filter
Top Products
Compare the results and then select the opti-
mal setting for your camera.
Manual flash mode M
Establish the necessary distance to the subject by
selecting a full or partial light output level taking
into account the lens aperture. Note the distance
indicated on the aperture calculator or the dis-
tance given on the LC display of the flash unit.
7. Troubleshooting hints
Should, for example the flash unit’s LC display in-
dicate meaningless information or should the flash
unit not function properly you can try to overcome
this problem as follows:
1a) Switch off the flash unit by its main switch.
1b) Remove its power sources.
1c) Switch on the flash unit for about 1 second
and then switch it off again.
1d) Reload the power sources.
or / and:
2a) Switch off the camera and the flash unit.
2b) Remove the SCA adapter from the flash unit
and then re-mount it again.
The flash unit should operate properly when it is
switched on again. Contact your local dealer
should this not be the case.
For up-to-date information please visit the Metz
Homepage: www.metz.de
34