National Instruments NI 17xx Digital Camera User Manual


 
Chapter 4 Lighting
NI 17xx Smart Camera User Manual 4-6 ni.com
The minimum voltage drop specified for the light does not fall below
the specified range of the smart camera. Under some circumstances
some LEDs, particularly certain lights with infrared LEDs and lights
with only one LED per string, present a lower voltage drop than usual
and may be incompatible with the smart camera. These lights may
need to be reconfigured by the manufacturer to bring the voltage drop
within the specified range of the smart camera.
Note The voltage drop of a light can vary significantly with environmental conditions,
such as ambient temperature, current supplied, and strobe time.
Refer to Appendix A, Specifications, for complete specifications for the
Direct Drive lighting controller.
Connecting a Light to the Direct Drive Lighting Controller
This section applies only to the following NI Smart Cameras:
Figure 4-2 illustrates how to connect a light to the Direct Drive lighting
controller. Do not use the GND signal when connecting a light to the Direct
Drive lighting controller.
Figure 4-2. Connecting a Light to the Direct Drive Lighting Controller
NI 1742 NI 1762
NI 1744 NI 1764
LED
LED
+
LED
NI 17xx
Direct
Drive