Filter
Top Products
17
Charging and Inserting the Battery
First Steps
1.4 Charging is complete when the CHARGE lamp stops blinking.
Remove the battery from the charger and unplug the charger.
2 Insert the battery.
2.1 After confirming that the power switch is in
the off position, open the battery chamber
cover.
2.2 Insert a fully charged battery as shown at
right. Close the battery chamber cover.
s
B Removing the Battery
Turn the camera off and confirm that the memory card access lamp is off before removing the
battery.
B The Battery and Charger
• Read and follow the warnings and cautions on pages ii–iii and 164–166 of this manual, together with
any warnings and instructions provided by the battery manufacturer.
• Do not use the battery at ambient temperatures below 0 °C (32 °F) or above 40 °C (104 °F). During
charging, the temperature should be in the vicinity of 5–35 °C (41–95 °F). For best results, charge
the battery at temperatures above 20 °C (68 °F). Battery capacity may drop if the battery is charged
or used at lower temperatures.
• The battery may be hot immediately after use. If so, wait for the battery to cool down before
charging.
• Replace the supplied terminal cover after removing the battery from the camera or the quick
charger to avoid shorting the battery.
• Unplug the quick charger when it is not in use.
EN-EL9
7.4V 1000mAh
CHARGE lamp
1
2
EN
-
E
L9
mAh
Be sure that the
battery contacts are
facing down.