Filter
Top Products
Technical Notes and Index
F9
Camera turns off
without
warning.
• The camera automatically turns off to save power
(auto off function).
• The camera or battery has become too cold and
cannot operate properly.
• The inside of the camera has become hot. Leave the
camera off until the inside of the camera has cooled,
and then try turning it on again.
23
F3
–
The monitor is
blank.
• The camera is off.
• The battery is exhausted.
• The camera has entered standby mode to save
power. Press the power switch, shutter-release
button, c button or b (e movie-record) button,
or rotate the mode dial.
• The flash lamp flashes while the flash is charging.
Wait for the flash to charge.
• The camera and computer are connected via a USB
cable.
• The camera and TV are connected via an HDMI cable.
• Interval timer shooting in progress.
• Wi-Fi is connected.
22
22
23
54
97,
101
97,
E15
E37
95,
E63
Monitor is hard
to see.
• Adjust the monitor brightness.
• The monitor is dirty. Clean the monitor.
92,
E68
F6
Date and time of
recording are
not correct.
• If the camera clock has not been set, the “Date not
set” indicator flashes during shooting and movie
recording. Images and movies saved before the clock
is set are dated “00/00/0000 00:00” or “01/01/2014
00:00” respectively. Set the correct time and date
from the Time zone and date option in the setup
menu.
• The camera clock is not as accurate as ordinary
watches or clocks. Periodically compare the time of
the camera clock with that of a more accurate
timepiece and reset as required.
24, 92,
E66
92,
E66
No information
displayed in
monitor.
Hide info is selected for Photo info of Monitor
settings in
the setup menu.
92,
E68
Prin
t date not
available.
Time zone and date has not been set in the setup
menu.
24, 92,
E66
Problem Cause/Solution
A