Filter
Top Products
1716
Step 1—Attach the Camera Strap and Lens Cap
Camera Strap
Lens cap
• Attach the strap as shown.
• Press the tabs on the lens cap to
attach/detach it.
• We recommend attaching the lens cap to the
strap loop with the supplied cord to prevent it
from being misplaced.
First Steps
3
Open the battery-chamber cover
• Pressing the battery-chamber cover latch ⁄, slide
the battery-chamber cover out ¤ and flip it open ‹.
Step 2—Insert the Battery
Your camera is powered by a single rechargeable Nikon EN-EL1
lithium-ion battery or a non-rechargeable 2CR5 (DL245) lithium battery
(available separately).
1
Charge the battery
• The EN-EL1 is not fully charged at shipment. A battery charger is provided
with the camera; we recommend that you charge the battery before use.
Instructions for charging the battery may be found in the instruction manual
included with the charger.
Introduction—First Steps
4
Insert the battery
• Insert a fully charged EN-EL1 or new 2CR5 (DL245) battery as shown in the
label on the underside of the battery-chamber cover.
EN-EL1 2CR5 (DL245)
5
Close the battery-chamber cover
Read Battery Warnings
Read and follow all warnings and instructions supplied by the battery
manufacturer.
• Close the battery chamber cover ⁄ and slide it to
the closed position ¤. To prevent the battery being
dislodged during operation, be sure that the battery
chamber cover is properly latched.
2
Turn the camera off
E4300 (E) 02.12.9 1:47 PM Page 16