Filter
Top Products
103
Technical Notes
10
Troubleshooting
If your camera fails to function as expected, check the list of common
problems below before consulting your retailer or Nikon representative.
Refer to the page numbers listed in the rightmost column for informa-
tion on solving the problems listed here.
Electronically-Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and
the camera may stop functioning. In most cases, this phenomenon is caused
by a strong external static charge. Turn the camera off, remove and replace
the batteries, and turn the camera on again, or, if you are using the EH-61 AC
adapter, disconnect and reconnect the adapter, and turn the camera on
again. In the event of continued malfunction, contact your retailer or Nikon
representative. Note that disconnecting the power source as described above
may result in the loss of any data not recorded to the memory card at the time
the problem occurred. Data already recorded to the memory card will not be
affected.
Problem Possible cause
Monitor is blank
• Camera is off.
• Battery is not correctly inserted or battery-chamber/
memory card slot cover is not securely closed.
• Battery is exhausted.
• EH-61 AC adapter is not properly connected.
• Camera is connected to the COOL-STATION.
• Audio/video cable is connected.
27
20
26
21
–
59
Camera turns off
immediately
• Battery is low.
• Battery is cold.
26
100
No indicators
appear in monitor
• Indicators are automatically hidden after five seconds.
Press the multi selector to display indicators again.
• Slide show is in progress.
15
84
Monitor is hard to
read
• Monitor brightness requires adjustment.
• Monitor is dirty. Clean monitor.
95
99
Photos are blurred
• Camera shook during shot. Blurring caused by cam-
era shake can be reduced by:
–Using the flash
–Using the Best Shot Selector (BSS)
–Using the self-timer with a tripod.
40
80
43