92
Multiple flash shooting using cords
■
■
■
TTL multiple flash (not possible with cameras compatible with CLS
and digital SLRs not compatible with CLS)
1
Set the camera’s exposure mode to Aperture-
Priority Auto (A) or Manual (M).
2
Attach the master flash unit to the camera, turn
the power on, and set the flash mode to TTL
auto flash.
• A flash mode, in which Monitor preflashes are fired,
cannot be used.
3
When using either the optional TTL Multi-Flash
Sync Cord SC-27,SC-26, SC-19 or SC-18, turn
off all flash units before connecting the master
flash unit to the remote flash units.
4
Turn on all remote flash units and set the flash
mode on all remote flash unit to TTL auto flash.
5
Confirm the aperture and flash shooting distance
as in normal TTL auto flash shooting, then shoot.
• See page 17 concerning the TTL auto flash mode.
• When the flash has fired at its maximum output and
underexposure may have occurred, the ready-light on
the SB-800 blinks for approx. 3 sec. To compensate,
use a wider aperture or move closer to the subject
and reshoot.
F
L
A
S
H
R
E
A
D
Y