Olympus C-300 ZOOM Digital Camera User Manual


 
If correct focus cannot be obtained
Shooting basics
2
46
3
Press until is displayed.
The setting changes in the sequence AF-
- each time is pressed.
When Quick Focus is set, the mark is
displayed on the monitor.
4
Press the shutter button fully.
To cancel Quick Focus mode, press repeatedly until AF is
displayed. The mark disappears.
Subjects that are difficult to focus on
Under certain types of conditions, the auto focus may not work properly. If this
happens, focus on an object with high contrast at the same distance as the
intended subject (focus lock), recompose your shot and then take the picture.
If the subject has no vertical lines, hold the camera vertically and focus the
camera using the focus lock function by pressing the shutter button halfway,
then return the camera to the horizontal position while keeping the button
half-pressed and take the picture.
Quick Focus is canceled when the lens barrier is closed. “Saving the
settings (All Reset)” ( p.110)
The green lamp on
the right of the
viewfinder blinks.
The subject cannot be
brought into focus.
The green lamp on
the right of the
viewfinder lights up,
but the subject cannot
be brought into focus.
Subject with low
contrast
Subject with an
extremely bright area in
the center of the frame
Subject without
vertical lines
Subjects at different
distances
Fast-moving subject The subject to be
focused on is not in the
center of the frame