Filter
Top Products
116
EN
11
Shooting tips and maintenance
Image turns out too bright or too dark
When taking pictures in S mode or A mode, the displayed shutter speed or aperture setting
may blink. A blinking display means that the correct exposure cannot be obtained. If you take
the picture as is, the picture will appear too bright or too dark. If that happens, change the
aperture setting or shutter speed.
g“Aperture priority shooting” (P. 41), “Shutter priority shooting” (P. 42), “Exposure warning
display” (P. 129)
Unknown bright dot(s) appear on the subject in the picture taken
This may be due to stuck pixel(s) on the image pickup device. Perform [PIXEL MAPPING]. If
the problem persists, repeat pixel mapping a few times. g“Pixel mapping k Checking the
image processing functions” (P. 122)
Additional shooting tips and information
Increasing the number of pictures that can be taken
The captured image will be recorded on the card. The following ways describe how to record
more images.
• Change the record mode.
The size of an image varies with the record mode. When you are not sure of the available card
capacity, change the image mode and shoot the picture. The smaller the image size and the
higher the compression, the smaller the size of the image becomes. To make the file size small,
combine the image size and compression rate and register it with [K SET].
You can further reduce the number of pixels by setting [PIXEL COUNT] to fewer pixels for image
size [X] or [W]. g“Selecting the record mode” (P. 61), “K SET” (P. 97), “PIXEL
COUNT” (P. 98)
• Use a card with large capacity.
The number of recordable images varies with the capacity of the card. Use a card with large
capacity.
Using a new card
If you use a non-Olympus card or a card used for another application, such as for a
computer, the message [CARD ERROR] is displayed. To use this card with this camera, use
the [FORMAT] function to format the card. g“Formatting the card” (P. 125)
Extending the useful life of the battery
Performing any of the following operations when not actually taking pictures can deplete the
battery power.
• Repeatedly pressing the shutter button halfway
• Repeatedly playing back the captured images over a long period of time
• Using the live view function over a long period
To save battery power, turn off the camera whenever it is not in use.
Functions that cannot be selected from menus
Some items may not be selectable from the menus when using the arrow pad.
• Items that cannot be set with the current shooting mode
• Items that cannot be set because of an item that has already been set:
Combination of [l] and [NOISE REDUCT.], etc.
s0011_e_00_0_unified.book Page 116 Wednesday, September 12, 2007 4:46 PM