Filter
Top Products
87
EN
7
Playback functions
Protecting selected frames
This function lets you select multiple images and protect them all at the same time during
single-frame playback or index display.
1 Display the images you want to protect and press the i button.
• The selected images will be shown with red frames.
• To cancel your selection, press the i button again.
• During index display, press p to select the images you want to protect and press the i
button.
2 Press p to display the next images you want to protect and press the i button.
3 After you have selected the images to protect, press the 0 button.
Canceling all protections
This function lets you cancel the protection of several images at one time.
1 MENU[q][RESET PROTECT]
2 Use ac to select [YES], then press the i button.
x Notes
• Formatting the card erases all images even if they have been protected.
g“Formatting the card” (P. 125)
• Protected images cannot be rotated even when the F button is pressed.
Lets you erase recorded images. You can select single-frame erase, which erases only the
currently displayed image; all-frame erase, which erases all the images stored on the card; or
selected frame erase, which erases only the frames selected.
x Notes
• When you perform all-frame or selected frame erase on images recorded using RAW+JPEG,
both the RAW and JPEG images are erased. When using single-frame erase, you can select
whether to erase the JPEG, RAW, or both RAW and JPEG images. g“RAW+JPEG
ERASE” (P. 98)
• Protected images cannot be erased. Cancel protected images, then erase them.
• Once erased, images cannot be restored. g“Protecting images” (P. 86)
Erasing images
s0011_e_00_0_unified.book Page 87 Wednesday, September 12, 2007 4:46 PM