Filter
Top Products
101
Chapter 7
Sleep timer
The camera automatically enters the sleep mode if the time you have set has
passed with no operations being performed. To leave the sleep mode,
operate any button (press the shutter button or arrow pad, etc.).
In the top menu, select MODE MENU T SETUP T SLEEP, then select a
setting from the following: 30SEC,1MIN, 3MIN, 5MIN or 10MIN.Press .
Press again to cancel the menu.
Factory default setting: 3 MIN
Available
modes
● The sleep timer does not work when using an AC adapter.
● The camera always turns off if the camera is left in playback mode for
about 3 minutes.
Note
Video output selection
You can select NTSC or PAL according to your TV’s video signal type. Select the
video signal type of your area before shooting. If you use the wrong video signal
type, you may not be able to play back the recorded images properly on your TV.
In the top menu, select MODE MENU T SETUP TVIDEO OUT T NTSC
or PAL. Press . Press again to cancel the menu.
● The factory default setting varies depending on the region where you
purchased this camera.
TV video signal types & main regions
NTSC : Japan, Korea, North America, Taiwan
PAL : China, European countries
Available
modes