Filter
Top Products
Preparation
27
Changing backlight brightness
The brightness of the LCD monitor backlight can
be adjusted between three different settings.
1
Select LCD BL in the LCD item on the
settings menu SW MODE screen.
LCD BL can be assigned with the LCD button.
2
Press the LCD button.
The brightness of the backlight can be switched
in the order of NORMAL→LOW→HIGH→
NORMAL with each press of the button.
LCD
This setting will remain saved even if the
camera’s power is switched off.
The brightness can also be changed with the
LCD BACKLIGHT item on the settings menu
DISPLAY SETUP screen. (Page 94)
•
•
Reversing image display
Viewing angles and video images can be verified
by reversing the images displayed on the LCD
monitor horizontally or vertically.
The recorded images will not be affected if the
images are reversed on the screen.
1
Select LCD REV in the LCD item on the
settings menu SW MODE screen.
LCD REV can be assigned with the LCD
button.
2
Press the LCD button.
Press the button to switch between normal
display and reverse display.
LCD
If the camera is switched off, images will be
displayed as normal again when the camera is
next switched on.
Screen displays other than images are also
reversed. If the screen displays are not
required, some of them can be cleared by
pressing the DISP/MODE CHK button.
During display reversal, the images during
REC CHECK and the playback images in the
PB mode are also reversed.
Images in the viewfinder will not be reversed.
•
•
•
•