Filter
Top Products
112
Adjustments and Settings for Recording
: RGB 4:4:4 Output and P-10LOG Settings
This unit can output signals suitable for Digital-Intermediate,
which is a film production workflow.
Link A signal is output from the HD SDI A connector and
Link B signal is output from the HD SDI B connector by
performing the cinematograph setting, and it is possible to
set these signals as P-10LOG for RGB 4:4:4 output. For
cinematograph settings, see page 109 and later.
Refer to the following procedures to set the above without
using the cinematograph setting.
1 Open the <GAMMA> screen from the PAINT page with
menu operation.
2 Select GAMMA MODE SEL using the JOG dial button,
and press the JOG dial button.
3 Turn the JOG dial button and select “FILM-REC”, then
press the JOG dial button.
4 Open <OUTPUT SEL> screen from SYSTEM SETTING
page with menu operation.
5 Select SIGNAL FORMAT using the JOG dial button, and
press the JOG dial button.
6 Turn the JOG dial button and select “4:4:4”, then press
the JOG dial button.
7 Select P-10LOG using the JOG dial button, and press
the JOG dial button.
8 Turn the JOG dial button and select “ON”, then press
the JOG dial button.
9 Press the MENU button to complete the menu
operation.
Notes
Recording to the P2 card and MON OUT signal will be
YP
BPR 4:2:2 even if the signal is set to P-10LOG for RGB
4:4:4.
If you select “ON” in P-10LOG setting, 2D-CMS will
operate in accordance with P-10LOG as well.
RGB 4:4:4 Output and P-10LOG Settings
RGB 4:4:4 Output and P-10LOG Settings
Example of Digital Cinema Recording
Film camera AJ-HPX3700G
Ð
Ð
Equipment to convert
film to digital data
Ð
Convert
film to
data
Hard disk recorder, etc.
Ð
Color grating process
Ð
Film recording
Ð
Film print
Ð
Screening
Transition Chart of FILM-REC Gamma to P-
10LOG
100
50
0
VIDEO-REC
FILM-REC
P-10LOG
1000
500
0
-
5 stop
-
4 stop
-
3 stop
-
2 stop
-
1 stop
Normal
+1 stop
+2 stop
+3 stop
+4 stop
-
6
-
5
-
4
-
3
-
2
-
10123456
30
NORMAL
18% GRAY
AJ-HPX3700G-VQT1V68_eng.book 112 ページ ２００８年１０月１５日 水曜日 午後６時３８分