Filter
Top Products
163
Maintenance and Inspections: Warning System
Maintenance and Inspections
The following error codes are displayed in the display window if an error occurs in the camera:
Confirm the type of warning and refer to the details in the [Warning Description Tables] (page 160) for countermeasures.
Error Codes
Code No. Description Type of warnings
E-11 Video initialization error 1. System Errors
E-27 Recording control error 1. System Errors
E-30 P2 card removal error 2. Card removal error
E-34 LCD microcontroller error 1. System Errors
E-38 P2 streaming microcontroller error 1. System Errors
E-39 Abnormal initialization of the AVC-Intra codec 1. System Errors
E-3F Microprocessor error in the camera control circuit 1. System Errors
E-40 Image sequence error (in case of 24P, 30P and 25P), GENLOCK error 5. Image Sequence Error (24P, 30P, 25P)
E-63 Something is wrong with the system control microprocessor. 1. System Errors
E-6F Reference signal error. 1. System Errors
00:00:00:11 Recording error on a P2 card 6. Recording Error/10. P2 Card Error
Card Warning Code
Code No. Description Recording
Indication in display
window
E-70
The directory structure on the P2 card is not
supported. ([DIR NG CARD (Slot No.)] is
indicated on the viewfinder.)
Operation continues. However, back up data
on the P2 card as soon as possible, and
format the card before using it again.
A warning code blinks once
every 2 seconds on the time
code display section of the
display window.
E-71
The maximum number of overwrites on the P2
card has been exceeded. ([RUN DOWN
CARD (Slot No.)] is indicated on the
viewfinder.)
Operation continues. However, recording or
playback may not operate correctly. It is
recommended that you replace the P2 card
with another one.
AJ-HPX3700G-VQT1V68_eng.book 163 ページ ２００８年１０月１５日 水曜日 午後６時３８分