Filter
Top Products
75
Adjustments and Settings for Recording
: Setting Time Data
Adjustments and Settings for Recording
By setting the DISPLAY switch to [CTL], CTL count is
displayed on the time count indication of the LCD display
window.
The CTL count is displayed in ±12 hours with non-drop-
frame.
The playback order of clips recorded on a P2 card is not
linear as for VTRs. It is organized according to thumbnail
operations or exchanging P2 cards, and the priority of
recorded clips will be altered. Therefore, different CTL
counts are displayed for recording mode and playback
mode, respectively.
Recording CTL count is displayed during recording mode
(REC, REC/PAUSE, STOP and REC REVIEW), and the
count continues from the end point of the previous
recording. Recording CTL count is retained even if the
power is turned off. When the power is next turned on, the
count continues from the previous value.
Notes
If the RESET button is pressed while the recording CTL
count is being displayed, only the recording CTL count is
reset. Note that reset is disabled during the REC REVIEW
operation.
24 frames are counted in the 24PN (Native) mode.
During playback mode (PLAY, FF, REW, PLAY/PAUSE),
playback CTL count is displayed.
Whenever the playback order of clips is altered (clips are
sorted by shooting dates), previous playback CTL count is
disabled. The first frame of the first clip is used as a
reference value for recalculation, and the new playback CTL
count is displayed.
The playback order of clips is altered when either of the
following occurs:
Clips are deleted, copied or restored, or the P2 card is
formatted.
The thumbnail display is switched (for more information,
see [Switching the Thumbnail Display] (page 130)).
A P2 card is inserted or removed.
The reference value (value of the first frame of the first clip)
is changed when either of the following occurs:
The power is turned on, the first frame becomes 0.
When the playback CTL count is reset, the current
playback position is set as 0, and the previous reference
value becomes a negative value.
Notes
If the RESET button is pressed while the playback CTL
count is being displayed, only the playback CTL count is
reset.
For playback in 24PN (Native) mode, 30 frames are
counted in accordance with the pull-down images.
Note, however, that in the 1080/23.98PsF and 1080/
24PsF modes, 24 frames are counted.
CTL Count Setting and Display
CTL count for recording mode (recording CTL)
CTL count for the playback mode
(playback CTL)
00:00:00:00
00:00:00:00
00:01:00:00 00:02:00:00 00:03:00:00
00:01:00:00 00:02:00:00
Current value
Current value
Clip 2 Clip 3
Clip 1 Clip 3
Example:
Delete Clip 2.
First frame
Clip 1
00:00:00:00
–00:03:00:00
00:01:00:00 00:02:00:00 00:03:00:00
–00:02:00:00 –00:01:00:00
00:00:00:00
Current value
Clip 1
Clip 2
Clip 3
Clip 1 Clip 2
Example:
Reset
First frame
First frame
Clip 3
AJ-HPX3700G-VQT1V68_eng.book 75 ページ ２００８年１０月１５日 水曜日 午後６時３８分