Filter
Top Products
164
Maintenance and Inspections: Warning System
Warning and Error Display for Thumbnail Operation and USB HOST MODE
Item Message Description Measure
Thumbnails
CANNOT ACCESS! Data cannot be accessed because it is corrupted
or for other reasons.
Restore media and clips to normal state before
access.
WRITE
PROTECTED!
The P2 or SD card is write protected. Insert write-enabled media.
CARD FULL! The P2 or SD card is full. Insert media with sufficient capacity.
NO CARD! No P2 or SD card is inserted. Insert compatible media.
NO FILE! The designated file is not found. Check the file.
CANNOT COPY! Images cannot be copied. Check the conditions for copying.
CANNOT DELETE ! Contents version mismatch prevents deletion. Match devices and contents version.
UNKNOWN
CONTENTS
FORMAT!
Warning displayed to indicate contents version
mismatch.
Match devices and contents version.
CANNOT FORMAT! P2 card problem prevents formatting. Check P2 card.
CANNOT REPAIR! Data cannot be repaired since content that
cannot be repaired is selected.
Check selected content.
CANNOT RE-
CONNECT!
A clip that does not span multiple P2 cards
cannot be reconnected.
Check selected content.
INVALID VALUE! Entered data was invalid. Enter data in a valid range.
UNKNOWN DATA! The metadata character code is invalid. Use UTF-8 for the metadata character code. Use
the viewer to enter correct characters.
CANNOT REPAIR IN
SELECTION!
Some of the selected clip could not be repaired.
NO SD CARD! No SD card is inserted. Insert an SD card.
NO COPY TO SAME
CARD!
A clip cannot be copied to the card storing the
original clip.
Copy the selected clip to a card that does not
contain the original clip.
SAME CLIP IS
SELECTED!
The clip cannot be copied because a clip that has
already been copied and the original clip have
been selected.
Confirm the selected clip and release either the
source clip or the destination clip and then
execute the copy operation.
USER CLIP NAME
MODIFIED!
Characters in the clip name had to be deleted in
adding the counter value.
The user clip name plus the counter value can
only contain up to 100 bytes. Characters in the
clip name are automatically deleted when the
total exceeds 100 bytes.
TOO MANY CLIPS! Too many clips are selected. Reduce the number of selected clips.
LACK OF REC
CAPACITY!
There is not enough recording capacity left on the
card.
Insert a card with sufficient recording capacity.
CANNOT CHANGE! Any thumbnails that cannot be produced on the
AVC-Intra100 or AVC-Intra50 and displayed in
gray cannot be changed at the text memo
position.
Set SYSTEM MODE according to the clips.
MISSING CLIP! A shot mark will be added to the clips recorded
on multiple P2 cards when all P2 cards are not
inserted yet.
Insert all P2 cards with recorded clips, and
confirm that the incomplete clip indicators
disappear, and then add shot marks.
Soft
keyboard
CANNOT CHANGE! [PERSON] will be entered while the text memo is
not available.
Enter [TEXT] before entering [PERSON].
CANNOT SET!
INVALID VALUE!
The entered value is incorrect. Change the value.
AJ-HPX3700G-VQT1V68_eng.book 164 ページ ２００８年１０月１５日 水曜日 午後６時３８分