Filter
Top Products
3
Read this first !
FRQWLQXHG
EMC NOTICE FOR THE PURCHASER/USER OF THE APPARATUS
1. $SSOLFDEOHVWDQGDUGVDQGRSHUDWLQJHQYLURQPHQW
7KHDSSDUDWXVLVFRPSOLDQWZLWK
standards EN55103-1 and EN55103-2 2009, and
electromagnetic environments E1, E2, E3 and E4.
3UHUHTXLVLWHFRQGLWLRQVWRDFKLHYLQJFRPSOLDQFHZLWKWKHDERYHVWDQGDUGV
!3HULSKHUDOHTXLSPHQWWREHFRQQHFWHGWRWKHDSSDUDWXVDQGVSHFLDOFRQQHFWLQJFDEOHV
The purchaser/user is urged to use only equipment which has been recommended by us as
peripheral equipment to be connected to the apparatus.
The purchaser/user is urged to use only the connecting cables described below.
!)RUWKHFRQQHFWLQJFDEOHVXVHVKLHOGHGFDEOHVZKLFKVXLWWKHLQWHQGHGSXUSRVHRIWKHDSSDUDWXV
Video signal connecting cables
Use double shielded coaxial cables, which are designed for 75-ohm type high-frequency
applications, for SDI (Serial Digital Interface).
Coaxial cables, which are designed for 75-ohm type high-frequency applications, are recommended
for analog video signals.
Audio signal connecting cables
If your apparatus supports AES/EBU serial digital audio signals, use cables designed for AES/EBU.
Use shielded cables, which provide quality performance for high-frequency transmission applications,
for analog audio signals.
Other connecting cables (IEEE1394, USB)
Use shielded cables, which provide quality performance for high-frequency applications, as
connecting cables.
When connecting to the DVI signal terminal, use a cable with a ferrite core.
If your apparatus is supplied with ferrite core(s), they must be attached on cable(s) following
instructions in this manual.
3. Performance level
The performance level of the apparatus is equivalent to or better than the performance level required by
these standards.
However, the apparatus may be adversely affected by interference if it is being used in an EMC
environment, such as an area where strong electromagnetic fields are generated (by the presence
of signal transmission towers, cellular phones, etc.). In order to minimize the adverse effects of the
interference on the apparatus in cases like this, it is recommended that the following steps be taken with
the apparatus being affected and with its operating environment:
1. Place the apparatus at a distance from the source of the interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the apparatus.
4. Connect the apparatus to another power outlet where the power is not shared by any other
appliances.
Pursuant to at the directive 2004/108/EC, article 9(2)
Panasonic Testing Centre
Panasonic Service Europe, a division of Panasonic Marketing Europe GmbH
Winsbergring 15, 22525 Hamburg, F.R. Germany