Filter
Top Products
53
<Note>
When a signal on which the LR information is superimposed is input to SDI1 such as when there is an
AG-3DA1 connection, that LR information is displayed on the right side of the signal format. If L and R are
incorrectly input, the LR information is displayed in yellow. If the LR information is input to SDI2 only, the
LR information is not displayed on the right side of the signal format.
+RZWRVZLWFKWKHDVVLVWIXQFWLRQ
Ŷ
Turn adjusting knob 4 (rightmost knob). Each turn clockwise switches the assist function in the order
shown in the table above.
<Notes>
When you switch to 3D assist mode, dedicated functions are assigned to the picture adjusting knobs and
FUNCTION3 button in the control section on the front panel.
When you want to make picture adjustments, switch to 2D mode.
To make picture adjustments while still in 3D assist mode, press the FUNCTION3 button to turn ON the 2D
picture quality adjustment mode, and then switch the function of the adjusting knob to the 3D assist mode
function.
(If you turn OFF the 2D picture quality adjustment mode (2D ADJUST), the adjusting knob is reset to the
3D assist mode function.)
The setting value is saved and the mode is returned to 3D assist mode when you press [ENTER] or when
10 seconds elapses after the setting value is changed.
+RZWRUHWXUQWR'PRGH
Ŷ
Select [2D] in "2D/3D ASSIST” of the main menu.
3D Assist Mode
FRQWLQXHG