Panasonic BTLH910GJ Camera Accessories User Manual


  Open as PDF
of 76
 
43
0DLQ0HQX
FRQWLQXHG
³:)09(&725´
Ŷ
The “WFM/VECTOR” function enables display of the waveform and vector display. Use “DISPLAY
SETUP” in the main menu to select “WFM” and “VECTOR” display. (page 50)
Press the button ([FUNCTION1] to [FUNCTION3] (page 39)) to which the “WFM/VECTOR” function has
been assigned to switch the display in the following order.
:)09(&7252))ĺ:)0<21ĺ:)0521ĺ:)0*21ĺ:)0%21ĺ9(&725[WR[
This assumes that the “WFM/VECTOR” function has been assigned to any of the [FUNCTION1] to
[FUNCTION3] buttons.
WFM is displayed in the order of the Y signal, R signal, G signal, and B signal.
Normal screen
WFM display
<ĺ5ĺ*ĺ%
VECTOR display
*
1
Press the
EXWWRQDJDLQ
Press the
EXWWRQDJDLQ
WFM
(waveform display)
VECTOR
(vector display)
These examples show 16:9 aspect ratio images.
Displayed only for SDI signal input.
*
1
The scale display is as shown below.
100 %
This dotted line is 109%.
A dotted line indicates for
each 10% increase.
This dotted line is -4%.
I axis
Q axis
The frame is ±2.5°, ±2.5 %
50 %
0 %
Press the FUNCTION button to which the WFM/VECTOR function has been assigned.
 previous next