Filter
Top Products
31
0DLQ0HQX
FRQWLQXHG
6XEPHQX 6HWWLQJV Description
SHARPNESS
MODE *
4
HIGH
LOW
Selects the width of outline correction edge.
<HIGH> Narrow edge
<LOW> Wide edge
SHARPNESS H *
4
0 - 30 Sets horizontal outline correction. The item display moves to
the lower part of the screen during adjustment.
SHARPNESS V *
4
0 - 30 Sets vertical outline correction. The item display moves to the
lower part of the screen during adjustment.
I-P MODE
*
5
MODE2
MODE1
Selects IP conversion mode. (see “IP mode” below.)
<MODE2> Intra-field interpolation
<MODE1> Intra-frame interpolation
MONO
OFF
ON
Switches between color and monochrome (MONO).
<OFF> Color
<ON> Monochrome
*
When ON, the CHROMA setting of the picture adjusting knob
is fixed at 0.
ANAMO
*
6
OFF
ON
With an Anamo lens and HD-SDI input, the picture is resized
to Anamo magnification (the vertically enlarged signal can be
vertically compressed and corrected for display).
SD ASPECT
4:3
16:9
Sets the aspect ratio for SD signal input.
<4:3> 4:3 display
<16:9> 16:9 display
SCAN
*
6
NORMAL
UNDER
Sets under-scan and normal display.
<NORMAL> Normal display
<UNDER> Under-scan
The following sharpness values are available and the settings for the selected input signal is displayed.
*
4
Adjustment status during selection appears at the bottom left of the screen.
1) VIDEO system input (VIDEO) (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS
H/V: 0)
2) HD for any other input (the factory defaults are SHARPNESS MODE: HIGH and SHARPNESS H/V: 0).
3) SD for any other input (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0).
To use the “SUB WINDOW” (page 42) function,
*
5
1) Change settings after exiting the “SUB WINDOW” function.
2) It is recommended to use “MODE2” for handling fast video.
“SCAN” changes are not reflected in Anamo size display.
*
6
IP mode
“MODE1” performs IP conversion using intra-frame interpolation.
This monitor suppresses the delay to within 1 field.
The factory default is “MODE1”.
“MODE2” performs IP conversion using intra-field interpolation.
Since interpolation is performed inside each field, this mode is suitable for checking interlace status.