Panasonic BTLH910GJ Camera Accessories User Manual


  Open as PDF
of 76
 
37
0DLQ0HQX
FRQWLQXHG
RESET operation
3UHVV>1. @> @LQWKH³6<67(0&21),*´
PHQXVHOHFWWKH>&$/,%5$7,21@VXEPHQX
DQGSUHVV>(17(5@
3UHVV>2.
@> @VHOHFWWKH>5(6(7@VXEPHQX
DQGSUHVV>(17(5@
MENU
EXIT
SEL.
ENTER
ENTER
[RESET]
YES
NO
6HOHFW³<(6´DQGSUHVV>(17(5@3.
This starts calibration.
MENU
EXIT
SEL.
ENTER
ENTER
[RESET]
xxxxxxxx
xxxxxxxxx indicates that the following message
with the meaning listed below appears.
COMPLETE: Operation completed
7XUQWKHSRZHURIIDQGWKHQRQDIWHU4.
SHUIRUPLQJDXWRFDOLEUDWLRQ
VF CONFIG
The underlined values are factory preset setting values.
6XEPHQX 6HWWLQJV Description
VF CONTROL
VF-CH
ALL-CH
Used to select the input line for the VF function of the monitor.
(VF function: tally lamps (red and green) lit, zebra displayed,
!
displayed, aspect changed [SD])
<VF-CH> Only enabled when the VF line is selected.
<ALL-CH> Enabled with all input lines.
REAR TALLY
OFF
ON
Used to allow control of the tally lamp on the rear of the monitor.
<OFF> Does not light.
<ON> Lights when TALLY control from a GPI/camera is ON.
ZEBRA
OFF
ON
Used to set ZEBRA information in the camera.
<OFF> Sets the information to OFF.
<ON> Sets the information to ON.
The priority sequence for GPI control and SERIAL is as follows: GPI > VF CONFIG > SERIAL.
 previous next