Filter
Top Products
135
VQT1T27
Others
• Is the [REC]/[PLAYBACK] selector switch at the [!] setting? (P29)
• Is the mode dial correctly set?
• Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P42)
• The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> If the lens is dirty, turn on the camera, eject the lens barrel (P11) and gently wipe the lens
surface with a soft dry cloth.
• Was this picture taken with the flash at the close range when the zoom is near [W] (1k)?
> Zoom in a little, and then take the pictures. (P38)
> Is this a picture taken in [PIN HOLE] in scene mode?
> Check that the exposure is correctly compensated. (P51)
• Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] to slower speed.
> Set auto bracket (P52), multi aspect (P53), [HI-SPEED BURST], [FLASH BURST] in scene
mode (P66, 67), or the burst mode (P54) to [OFF].
• The focus range varies depending on the recording mode.
> Set to the proper mode for the distance to the subject.
• The subject is beyond the focus range of the camera. (P32)
• There is camera shake (jitter) or the subject is moving slightly. (P34)
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P32)
> When taking pictures at a slow shutter speed, use the self-timer. (P50)
• Is the number of recordable pictures 2 or less?
• Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [AUTO] when the camera is shipped. Therefore, when taking pictures
indoors etc. noise will appear.)
> Decrease the ISO sensitivity. (P78)
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The recorded picture is blurred.
The optical image stabilizer is not effective.
Taking pictures using auto bracket/multi aspect is not possible.
The recorded picture looks rough.
Noise appears on the picture.
P.PC_DMC-LX3_eng.book 135 ページ ２００８年７月８日 火曜日 午後１０時１３分