Filter
Top Products
VQT1T27
46
Advanced (Recording pictures)
[REC] mode:
Taking Pictures using the Built-in Flash
A To open the flash
Press the flash open button.
B To close the flash
Press the flash until it clicks.
•
Be sure to close the flash when not
in use.
• The flash setting is fixed to [Œ]
while the flash is closed.
Set the flash to match the recording.
•
Open the flash.
Press 1 [‰].
Press 3/4 to select a mode.
• You can also press 1 [‰] to select.
• For information about flash settings that can be selected, refer
to
“Available flash settings by recording mode”. (P47)
Press [MENU/SET].
• You can also press the shutter button halfway to finish.
• The menu screen disappears after about 5 seconds. At this time, the selected item is
automatically set.
Switching to the appropriate flash setting
Item Description of settings
‡: AUTO
The flash is automatically activated when the recording conditions make
it necessary.
:
AUTO/Red-eye
reduction
¢
The flash is automatically activated when the recording conditions make
it necessary.
It is activated once before the actual recording to reduce the red-eye
phenomenon (eyes of the subject appearing red in the picture) and then
activated again for the actual recording.
• Use this when you take pictures of people in low lighting
conditions.
‰: Forced flash ON
:
Forced ON/Red-eye
reduction
¢
The flash is activated every time regardless of the recording conditions.
• Use this when your subject is back-lit or under fluorescent light.
• The flash setting is set to [ ] only when you set [PARTY] or
[CANDLE LIGHT] in scene mode. (P62)
OPEN
1
2
3
P.PC_DMC-LX3_eng.book 46 ページ ２００８年７月８日 火曜日 午後１０時１３分