Filter
Top Products
Preparation
12
Inserting the Battery
[Preparation]
• Check that the power switch is set to [OFF]
and the lens is retracted.
• Close the flash. (P37)
[Inserting the battery]
1 Slide the lever in the direction of the
arrow to open the Memory Card/
battery door.
2 Insert the charged battery all the way
in, until it is locked.
3 Close the Memory Card/battery door.
[Removing the battery]
1
Open the Memory Card/battery door.
2
Slide the lock 1 in the direction of the
arrow to remove the battery.
3
Close the Memory Card/battery door.
• If you will not be using the camera for a long
time, remove the battery.
• When the fully charged battery is inserted in
the camera for more than 1 hour, the clock
setting is memorized by the camera for
about 24 hours even after the battery is
removed. (The time may be shorter if the
battery is not charged sufficiently.)
When the clock setting is cancelled, please
set the date/time again. (P28)
• When the card is being accessed, do not
open the Memory Card/battery door.
• The battery supplied with this camera is
exclusively designed for this camera. Do not
use with any other equipment.
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type recommended by
the manufacturer. Dispose of used
batteries according to the manufacturer’s
instructions.
3
2
3
2
OPEN
OPEN
FZ2-PP.book 12 ページ ２００３年９月２６日 金曜日 午後１２時１分