Filter
Top Products
- 40 -
Advanced-Shooting
Available ash settings by recording mode
The available ash settings depend on the
recording mode.
(○ : Available, — : Not available, ◎ : Initial
setting)
Û2 It becomes Forced Flash ON [t],
when the backlight compensation
function is activated.
The ash setting may change when you
change the recording mode. Change the
ash setting again if necessary.
Flash settings are retained even if you
switch the camera off. However, scene
mode ash settings return to the factory
settings when you change the scene mode.
■
•
•
The available ash range to take
pictures
ISO sensitivity
Available ash range
AUTO 30 cm to 5.9 m (Wide)
30 cm to 3.2 m (Tele)
ISO100 30 cm to 1.8 m (Wide)
30 cm to 1.0 m (Tele)
ISO200 40 cm to 2.6 m (Wide)
30 cm to 1.4 m (Tele)
ISO400 60 cm to 3.7 m (Wide)
40 cm to 2.0 m (Tele)
ISO800 80 cm to 5.3 m (Wide)
60 cm to 2.9 m (Tele)
ISO1600 115 cm to 7.5 m (Wide)
90 cm to 4.1 m (Tele)
The available focus range differs
depending on the recording mode.
When you use the ash when you
have set ISO sensitivity to [AUTO], ISO
sensitivity automatically becomes a
maximum of [ISO1000]. ([ISO400] in the
[BABY1]/[BABY2] modes and [ISO800] in
the [PET] or [SPORTS] modes)
The edges of the picture may appear
dark if you shoot a very close subject with
the ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
Available ash range varies depending
on ISO sensitivity in [HIGH SENS.].
W: approximately 115 cm to 15 m
T: approximately 90 cm to 8.3 m
■
•
•
•
•
–
–