Filter
Top Products
13
G
e
t
t
i
n
g
S
t
a
r
t
e
d
Power Supply
Charge the Battery Pack on the AC Adaptor
1Connect AC Cable (supplied) to AC
IN on the AC Adaptor and plug the
AC Adaptor into an AC outlet.
• POWER LED lamp will light.
• Disconnect DC Cable if it is
connected to AC Adaptor.
2Attach the battery as shown to
charge.
• Charge Lamps on the AC Adaptor
will flash and then turn solid green to
indicate current charge level. When
all 4 lamps are constantly on, the
battery is fully charged. (approx. 1
hour 20 minutes.)
3Remove the Battery.
Slide the Battery out and then lift up.
• The four Charge Lamps “25%”, “50%”, “75%” and “100%” flash and then remain lit one
after another to indicate how much the Battery has been charged. When all four lamps
are lit, charging is finished.
• The Charge Lamps give a good approximate indication of the charging condition under
normal ambient temperature. However, when charging at high or low temperature, the
charge lamps may differ considerably from the actual charging condition.
Battery Charging Confirmation Marker
Use this marker as a reminder to yourself
when the battery is fully charged or in need
of a charge. This marker performs no
function and is for your reference only.
• The Battery is no longer serviceable if the
operation time is very short, even after a
sufficient charge.
About the Charge Lamps
25
50
75
100%
POWER
POWER Lamp
Charge Lamp
AC Adaptor
AC Cable
SD4090.p1-21.p65 99/11/11, 16:3813