Filter
Top Products
60
For assistance, call 1-800-272-7033.
• If the USB Cable (Supplied) is connected before the AC Adaptor is connected, or, if the
AC Adaptor is disconnected before the USB Cable is disconnected, it is possible that
Macintosh will abort the operation.
• The USB Cable (supplied) must be disconnected as described in the above steps.
Note
Disconnection
1End all applications and close all windows. (i.e. QuickTime, PhotoDeluxe, etc.)
2Eject the Disk Media from the Digital Camera. (See page 17.)
3Disconnect the USB Cable (supplied) from your PC and change the POWER
Switch on the Digital Camera setting from PC mode to another selection. Make
sure that all of the applications and all of the windows are closed. Then press the
SHTR button.
• When the PC recognizes the Disk Media, an icon, like the one
shown right, is displayed on the desktop.
• You can remove Disk Media from the Digital Camera by drag-
ging and dropping the Disk Media icon on the desktop into the
“Trash” icon.
• While the PC is starting up, the Disk Media cannot be removed,
even if the EJECT button on the Digital Camera is pressed.
• When a damaged Disk Media is inserted in the Digital Camera,
the Disk Media icon will not appear on the PC desktop. In this
case, the Disk Media can be removed by pressing the EJECT
button on the Digital Camera.
Removing the Disk Media
Transferring Your Images (Macintosh)
SD4090.p45-66.p65 99/11/11, 16:4060