Filter
Top Products
109
LSQT1337
Cautions for use
≥ The unit and SD card become warm after long
operation, but this is not a malfunction.
Keep the SD Card/Hard Disk Video Camera as
far away as possible from electromagnetic
equipment (such as microwave ovens, TVs,
video games etc.).
≥ If you use the SD Card/Hard Disk Video
Camera on top of or near a TV, the pictures
and sound on the SD Card/Hard Disk Video
Camera may be disrupted by electromagnetic
wave radiation.
≥ Do not use the SD Card/Hard Disk Video
Camera near cell phones because doing so
may result in noise adversely affecting the
pictures and sound.
≥ Recorded data may be damaged, or pictures
may be distorted, by strong magnetic fields
created by speakers or large motors.
≥ Electromagnetic wave radiation generated by
microprocessors may adversely affect the SD
Card/Hard Disk Video Camera, disturbing the
pictures and sound.
≥ If the SD Card/Hard Disk Video Camera is
adversely affected by electromagnetic
equipment and stops functioning properly, turn
the SD Card/Hard Disk Video Camera off and
remove the battery or disconnect AC adaptor.
Then reinsert the battery or reconnect AC
adaptor and turn the SD Card/Hard Disk Video
Camera on.
Do not use the SD Card/Hard Disk Video
Camera near radio transmitters or high-
voltage lines.
≥ If you record near radio transmitters or
high-voltage lines, the recorded pictures and
sound may be adversely affected.
Make sure to use the supplied cords and
cables. If you use optional accessories, use
the cords and the cables supplied with them.
Do not extend the cords and the cables.
Do not spray insecticides or volatile
chemicals onto the unit.
≥ If the unit is sprayed with such chemicals, its
body may be marred and the surface finish
may peel off.
≥ Do not leave rubber or plastic products in
contact with the unit for a long time.
When you use the unit in a sandy or dusty
place such as a beach, do not let sand or fine
dust get into the body and terminals of the
unit.
Also, keep the unit away from sea water.
≥ Sand or dust may damage the unit. (Care
should be taken when inserting and removing
an SD card.)
≥ If sea water splashes onto the unit, wipe off the
water with a well wrung cloth. Then wipe the
unit again with a dry cloth.
When carrying the unit, do not drop or bump
it.
≥ A strong impact can break the unit’s casing,
causing it to malfunction.
Do not use benzine, paint thinner or alcohol
for cleaning the unit.
≥ Before cleaning, detach the battery or pull out
the AC cable from the AC outlet.
≥ The camera body may be discolored and the
surface finish may peel off.
≥ Wipe the unit with a soft dry cloth to remove
dust and fingerprints. To remove stubborn
stains, thoroughly wring a cloth that has been
soaked in a neutral detergent diluted with
water and wipe the unit with it. Afterwards,
wipe it with a dry cloth.
≥ When you use a chemical dust cloth, follow the
instructions that came with the cloth.
Do not use the unit for surveillance purposes
or other business uses.
≥ This unit was designed for consumer
intermittent use. It was not intended for
continuous use, or for any industrial or
commercial application resulting in prolonged
use.
≥ In certain situations, continuous use could
cause the unit to overheat and cause a
malfunction. Such use is strongly discouraged.
About this unit
SDR-H60&41&40P&PC&PL-LSQT1337_mst.book 109 ページ ２００７年１１月１２日 月曜日 午後１時４６分