Filter
Top Products
42
LSQT1337
This unit will resume recording/pause mode
about 1.7 seconds after the LCD monitor is
reopened.
≥ When in quick start standby mode about
60% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
¬Rotate the mode dial to select or
.
1 Select the menu. (l 28)
2 Close the LCD monitor while the
mode dial is set to or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause approx. 1.7 seconds
after it is turned on.
To cancel Quick start
Select [SETUP] # [QUICK START] # [OFF]
≥ The default setting is on.
≥ Quick start standby mode is canceled if
jabout 5 minutes elapsed
jthe mode dial is switched
jthe battery is removed or the AC adaptor is
disconnected
≥ In the quick start mode it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
≥ In the quick start mode, the zoom
magnification becomes 2k and the picture size
may differ from what it was before quick start
standby mode.
≥ If [POWER SAVE] (l 29) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
Reduces the image shaking (jitter) due to hand
movement when recording.
¬Rotate the mode dial to select or
.
Press the O.I.S. button.
The image stabilizer icon [] appears.
To cancel the image stabilizer function
Press the O.I.S. button again.
≥ The default setting is on.
≥ In the following cases, the image stabilizer
function may not work effectively.
jWhen the digital zoom is used
jWhen the unit is shaken greatly
jWhen you record a moving subject while
tracking it
Quick start
[SETUP] # [QUICK START] # [ON]
A
A
Image stabilizer function
O.I.S.
SDR-H60&41&40P&PC&PL-LSQT1337_mst.book 42 ページ ２００７年１１月１２日 月曜日 午後１時４６分