Filter
Top Products
32 C2443M-C (1/04)
<Window Blanking>
Window blanking allows a user to program up to eight, four-sided, user-defined areas that
cannot be viewed by the operator of the dome system. A blanked area will move with pan and
tilt functions and automatically adjust in size as the lens zooms telephoto and wide.
Spectra III SE has two style modes for window blanking, GRAY and SMEAR. If style is set to
gray, the blanked area is covered with a solid gray window. If smear is selected images behind
the window will be noticeable but not distinguishable.
To set a window blanking area:
1. Use the joystick to position the cursor beside WINDOW BLANKING. Press Iris Open.
The WINDOW BLANKING menu appears on the screen.
2. Move the joystick to position the cursor beside SET WINDOWS. Press Iris Open to enter.
3. Position the cursor beside WINDOW NUMBER. Press Iris Open. The cursor moves to
the right.
4. Move the joystick up or down to view selections. Press Iris Open to enter selection.
5. Use the joystick to position the cursor beside EDIT WINDOW LOCATION. Press Iris
Open, and then follow the instructions that appear on the screen.
NOTE: Use the inside corner of the window selection
tool as a guide when selecting the upper left, upper right,
bottom right, and bottom left corners of the window.
NOTE: Set windows are not visible when editing a new window location.
When all four corners are set, the SET WINDOWS menu reappears, the blanked area
is displayed, and the ENABLE WINDOW option is set to YES.
BACK
EXIT
STYLE GRAY
BLANK ALL ABOVE OFF
BLANK ALL BELOW OFF
<SET WINDOWS>
WINDOW BLANKING
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<ALERT>*
<CLEAR>
<PASSWORD>
DOME SETTINGS
INSIDE CORNER
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
WINDOW NUMBER 1
<EDIT WINDOW LOCATION>
<EDIT WINDOW ZOOM>
ENABLE WINDOW NO
REVERSE
CLEAR WINDOW
SET WINDOWS
* This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.