Filter
Top Products
C2963M-C (8/10) 12
Installation
You can install the IDE Series network dome system using one of the following methods:
• Installation in a suspended ceiling or a fixed ceiling/wall (refer to In-Ceiling Installation on page 12).
• Mounting to the surface of a ceiling/ wall (refer to Surface Installation on page 14).
• Installation using the ID-P pendant mount accessory (not supplied). For pendant mount installation instructions, refer to the documentation
supplied with the pendant mount.
IN-CEILING INSTALLATION
1. Prepare the mounting surface:
a. Cut a 6-inch diameter hole in the ceiling.
b. Pull all wiring through the hole and terminate all wires (if not already terminated).
2. Install the lens on the back box:
NOTE: Megapixel lenses are designed and tested to deliver optimal image quality to megapixel cameras. A standard definition lens
installed on a megapixel camera will limit the resolution of the camera and create poor image quality.
a. Remove the cover from the lens mount.
b. Screw the lens onto the lens mount. Be careful to prevent dust from entering the space between the lens and the imager. If necessary,
use clean, compressed air to remove any foreign matter (refer to the instructions shipped with the lens). Make sure the lens does not
touch the camera imager when installed.
c. Connect the auto iris lens to the 4-pin connector located on the side of the camera. Pin connections for the iris drive connector are as
follows:
Figure 2. Lens Pin Connections
3. Connect the wiring to the side of the back box:
a. Connect the network cable to the RJ-45 network port on the side of the camera. If the network has no PoE, connect a 24 VAC Class 2
power supply to the 24 VAC power connector. Refer to Wiring on page 19 for wiring connections.
b. Connect the necessary wiring for alarms and relays (refer to Wiring on page 19 more information.)
4. Install the back box by compressing the spring clips and pushing the back box through the hole. Tighten the machine screws completely to
secure the back box to the ceiling.
Figure 3. In-Ceiling Installation
WARNING: Remove the foam insert from the back box before installing the system. The foam is inserted to secure the tilt ring; preventing
damage to the optical chassis during shipment.
3
12
4
Pin DC (AID) Auto Iris Lens
1 Control coil negative (–)
2 Control coil positive (+)
3 Drive coil positive (+)
4 Drive coil negative (–)