Filter
Top Products
23 C2963M-C (8/10)
Operation
DEVICE CONFIGURATION SEQUENCE
Once the device is installed and power is applied, the device will start a configuration sequence: the green LED flashes five times per second for
approximately two minutes and then glows solid green, indicating that the boot cycle is complete and the device is on line.
NOTE: If the device is not connected to a Dynamic Host Configuration Protocol (DHCP) server and DHCP is enabled, the configuration sequence
might take up to five minutes to complete.
Refer to the following sections for more information:
• Network Tab on page 33
• Turning On DHCP on page 34
• Turning Off DHCP on page 34
MINIMUM SYSTEM REQUIREMENTS
Network and processor bandwidth limitations might cause the video stream to pause or appear pixilated when additional Web-interface users
connect to the camera. Decrease the images per second (ips), resolution, compression, or bit rate settings of the Web interface video streams to
compensate for network/processor limitations.
The following minimum system requirements are needed to use a Web browser with the IP camera:
Processor: Intel
®
Core
™
2 Duo microprocessor, 2.6 GHz
Operating system: Microsoft
®
Windows
®
XP, Windows Vista
®
, or Mac
®
OS X 10.4
Memory: 2 GB RAM
Network interface card: 100 megabits (or greater)
Monitor: Minimum of 1024 x 768 resolution, 16- or 32-bit pixel color resolution
Web browser: Internet Explorer
®
7.0 (or later) or Mozilla
®
Firefox
®
3.0 (or later)
Media player: Pelco’s Media Player or QuickTime
®
7.6.5 for Windows XP and Windows Vista, or QuickTime 7.6.4 for Mac OS X 10.4 (or later)
NOTE: This product is not compatible with QuickTime version 7.6.4 for Windows XP or Windows Vista. If either operating system is installed on
your computer, upgrade to QuickTime version 7.6.5.
Refer to the following sections for more information:
• Compression Standards on page 55
• Available Camera Resolution on page 56
• Image Rate on page 56
• Bit Rate on page 56