Filter
Top Products
15 C2963M-C (8/10)
5. Apply power to the camera. The camera will complete a configuration sequence; the green LED flashes five times per second for
approximately two minutes and then turns solid after the sequence is complete.
NOTE: If the camera is not connected to a DHCP server and DHCP is enabled, the configuration sequence might take up to five minutes to
complete.
6. Position the camera:
a. View the camera image using the service jack or a Web browser.
b. Unlock the tab locks located on each side of the camera.
c. Manually rotate and tilt the camera module to position the camera. Do not over-rotate the module.
d. Lock the tab locks to secure the camera.
Figure 7. Positioning the Camera
7. Focus the lens:
a. View the camera image using the service jack or a Web browser.
b. Press the auto back focus button once to center the focus mechanism. The button is located on the rim of the back box.
c. Manually adjust the zoom and focus of the lens to the desired field of view (refer to the instructions shipped with the lens).
d. Press and hold the back focus button for three seconds to start the auto back focus mechanism.
8. Install the dome liner and lower dome (refer to Dome Liner and Lower Dome Installation on page 16).
ì
Pan 368°
î
Tab lock
ï
Rotate 355°
ñ
Tilt 160°