Filter
Top Products
99
3
Taking Pictures
By using this function, you can correct camera shake during shooting.
You can select the optical correction only (Sensor Shift) or both the
optical and electronic correction (Dual). The default setting is [Sensor
Shift].
1
Use the four-way controller (23) to select [Shake
Reduction] in the [A Rec. Mode] menu.
2
Press the four-way controller (5).
A pull-down menu appears.
3
Pres the 4 button.
The setting is saved.
When [Highlight Correction] is set to O, the minimum sensitivity is 200.
Setting the Shake Reduction
Sensor Shift For correcting camera shake optically only
Dual For correcting camera shake both optically and electronically
Off Neither optical nor electronic camera shake correction is performed.
•In 9 (Green) mode, the setting is fixed to [Sensor Shift].
• [Dual] cannot be set in the following situations:
- when . (Fireworks), c (Digital SR), X (Digital Wide), F (Digital
Panorama) or N (Frame Composite) is selected as the capture mode
- when the sensitivity is set to 3200 or 6400
- when g (Self-timer), j (Continuous Shooting), A (Burst Shooting(L)), C
(Burst Shooting(H)), i (Remote Control), h (0-sec Remote Control) or
l (Auto Bracketing) is selected as the drive mode
- when the flash is activated
- when the picture is taken without pressing the shutter release button
halfway
• For correcting camera shake in C (Movie) or c (Time-Lapse Movie) mode,
use the Movie SR function (p.114).
• When [Dual] is set, the optical correction is used whenever the camera can
correct shaking optically.