209
6
Shooting Settings
6
When a spot area is selected, use the four-way controller
(2345) to move the frame to the position you want to
measure.
7
Press the 4 button.
The white balance fine-tuning screen
appears when measuring is completed.
Adjust the white balance as necessary.
(p.207)
8
Press the 4 button.
The camera returns to the [White Balance] screen.
9
Press the 4 button.
The camera is ready to take a picture.
• No image is recorded when the shutter release button is pressed to adjust
the white balance.
• The message [The operation could not be completed correctly] appears
when measuring is unsuccessful. Press the 4 button while displayed to
remeasure the white balance.
• If a picture is extremely overexposed or underexposed, the white balance
may not be adjusted. In this case, adjust exposure to the correct amount level
before adjusting the white balance.
• When the mode dial is set to C (Movie), the white balance cannot be
measured. Adjust the white balance in any exposure mode other than C
before recording a movie.
Cancel Check
Manual
White Balance
Adjust
OK
OK
MENU
SHUTTER
GG
BBA
A
A
MM
±0 ±0
±0
AE.L
1
1