Filter
Top Products
EN-93
Maintaining a waterproof seal
Every SeaLife housing is tested for quality and a waterproof seal. It is your responsibility to properly care
for the O-ring and O-ring contact surfaces to maintain a waterproof seal. Carefully follow these important
O-ring care instructions. Not following these care instructions may cause the waterproof housing to leak
and void your warranty.
1. Carefully
inspect O-ring and O-ring contact surfaces for damage (cuts, scratches, tears, cracks, dents
and any other imperfections.)
before every use. Rub finger along O-ring and O-ring contact surfaces to
inspect for damage. Replace O-ring or have waterproof housing serviced if the O-ring or O-ring contact
surfaces are damaged. Do not use underwater housing if O-ring or O-ring contact surfaces are damaged.
Replacement O-rings are available at your local authorized SeaLife dealer.
Inspect and replace O-ring if damaged: A=Cut, B=Tear, C=Dent
1. Carefully inspect and
clean O-ring and O-ring contact surfaces for sand, hair and other debris before
every use. Clean o-ring and o-ring contact surfaces with cleaning brush provided in Care Kit.
Inspect and clean O-ring and O-ring contact surface for hair or fibers (#1) and Sand, Salt or debris (#2)
Clean O-ring and O-ring contact surfaces with brush provided in Care Kit.
3. Make sure O-ring is completely seated into O-ring groove before sealing housing. O-ring must not be
twisted when seated in the o-ring groove. See page 95 on instructions on how to install and remove O-
ring.